Two pizza orders in one delivery bag: which boxes stay after the first stop?
A ticket on a pizza bag can identify the whole bag when it holds one order. When two orders share the bag, the driver needs to identify the boxes leaving at the first stop and the ones still inside. Before asking for a ticket pocket on a custom carrier, test whether a second person can make that distinction with the boxes closed.

Run the handoff in both directions
Use your usual closed cartons and two fictitious orders. Give one order multiple boxes if that happens on your route. Put the same order reference on each box in that group and write its box count on the dispatch ticket. Place the mark where it can be read as the box is taken out. Two tickets beside an unmarked stack still leave the receiver guessing which box goes with which ticket.
Have a colleague who did not pack the bag take the first order. Compare the boxes handed over with its ticket, then read the marks and count the boxes left for the second stop. Reset and reverse the delivery order. Note when a reference disappears under another box or leaves the bag on the first ticket. If the receiver has to rely on memory, move the marks and repeat. If the remaining order still cannot be identified, assign separate bags.

Test a two-box order before choosing a ticket window
Try this sample exercise using your normal cartons, provided the bag closes freely with the load. Assign two boxes to A and one to B. Ask for A first. Taking one A and one B gives the correct count but the wrong order. Read both outgoing marks, then check that only B remains. On the next run keep the stack unchanged and request the bottom carton first.
A mark on the lid can disappear beneath the next carton. An edge mark visible on the counter can disappear behind the bag wall. Note where the receiver first has to put down another customer's box to read the mark. Repeat on the surface actually available at the stop. If the route offers nowhere suitable to set it down, assign separate bags on that route.
| Observation | Change and retest |
|---|---|
| Right ticket, wrong box | Mark each carton and repeat with another receiver. A larger window still identifies only the bag. |
| Handle hides the ticket | Send a photo with handles raised and the actual ticket size. Repeat the carry and opening steps with the proposed window on the sample. |
| Old ticket still visible on reload | Add removal to the empty-bag handover. If paper catches or tears, mark the snag on the sample before approving the pocket. |
What to send with the sample request
The YUANEN pizza bag shown here has a low, wide body and red handles. Specify any ticket holder separately. Send a blank ticket in the size used by the store and say when staff must read it: with the lid closed at dispatch, or while removing boxes at a stop. On the sample, grasp the handles and open the zipper as usual. Check that the ticket is readable at the agreed step and can be removed completely before the next run. Record the sample revision and the handoff that failed if a change is needed.
Keep a short record with the sample: sample revision ___, carton format ___, A/B counts ___, delivery sequence ___, first hidden mark ___, temporary resting place ___, change to test ___. When comparing two pocket positions, repeat the same loading sequence so a different stack cannot disguise the original problem.
Sources and scope
Check the cited sources. Product specifications are subject to order confirmation and the agreed sample. This article is not a product test report or a regulatory certification.
